User's Manual

9
®
4.2.2 Network Parameter
*Wired Setting
[DHCP]
If the router allows DHCP functionality, select DHCP. The IP Camera will obtain IP address
automatically from the router. If the router does not allow for DHCP functionality, then the IP address must be
obtained manually.
[IP address]
Set wired cable IP address of IP camera device.
[Subnet mask]
Default: 255.255.255.0 (It is highly recommended not to change this setting)
[Gateway]
Set gateway IP of IPC, for example if IPC access public network through router, the gateway IP
need to be set as the router IP which has accessed the public network.
[MACaddress]
MAC address of IP camera (Read only, cannot change)
[DNS address]
If the user has a DDNS account, the DNS address needs to be set as DNS address of the
place where the device is belonging to.
After setting parameters, click the [Submit] button, the setting will take effect immediately.
Figure 4-5 Wired Network Setting
Note: When the network parameter has been revised and saved, the device will reboot. If it is applied in
LAN, please make sure IP address does not conict with the IP address of other devices or computer in
the same LAN.
*WIFI Setting
[WIFI]
Select this check to open the wi network function of IPC.
[DHCP]
If the router allows DHCP function, select this type, IP camera will obtain IP address automatically from
router.
[IP address]
Set wireless IP address of IP camera.
[Gateway]
Set IP address of the current wireless gateway( router/AP), such as 192.168.0.1.
[Wireless Network Connection]
After enabling the Wireless setting, the software will automatically search for
available Wireless networks. The name of all wireless signals including signal intensity and the encryption will
be listed on the screen.