User's Manual

You will need to check each port for connectivity using this tool.

Enter 80 into the PORT NUMBER eld, then click CHECK. You should receive the folling notation: PORT80 is

OPEN on XXX.XXX.XXX.XXX

Note: The remote access that you see is your IPC’ external address. This is the IP address you will see when

you access your IPC via other different computers. Please write this down.

If the port is open, then you can visit remotely the IP camera via DDNS domain name at : http://jerry123.zapto.

org or http://xxx.xxx.xxx.xxx:80

FCC Statement

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference.

(2) This device must accept any interference received, including interference that may cause undesired

operation.

2. Changes or modications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference

by one or more of the following measures:

◆

Reorient or relocate the receiving antenna.

◆

Increase the separation between the equipment and receiver.

◆

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

◆

Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment. This equipment should be installed and operated with

minimum distance 20cm between the radiator & your body.