Manual

Commercial Series Special Duty Cameras
2301 Cube Mount 190 Degree Adjustable Camera
2302 Flush Mount 190 Degree Adjustable Camera
All Aluminum Housings
4 Pin Heavy Duty Water Resistant Connectors
5.5 - 36 Vdc Operational Power Supplies
190 Degree Adjustable Viewing Angle
Adjustable / Selectable Park lines
High Resolution 1280 X 720 Imager
Normal / Mirror Image Adjustment
The camera comes set to reverse image as a default setting, designed to be installed in the
rear of the vehicle. If you need to change it to a forward or “normal” image view, follow these
steps: 1: Disconnect the Camera at the 4 Pin connector 2: Clip the green wire at the power
supply on the cable (do not cut off the wire). 3: Use tape or heat shrink to protect the wires,
do not allow the cut ends to touch each other. 4: Re-connect the 4 Pin connector. If you need
to return to reverse image, re-connect the green wires together.
NOTE: You must always disconnect the power when changing the image mode.
Camera Parking Line and Viewing Angle Adjustment
The Viewing Angle (Up, Down, Right, Left, and Roll Right & Left) as well as the Parking Line
Angle, Size, and Width all can be adjusted and customized using the optional
Zorg 2303 Programmer (Not Included). Detailed instructions are included with the programmer.
The video cable supplies Power, Ground, and Video to the camera and back to the monitor.
If using this camera with a monitor that requires a different type of connection please
see our website (WWW.ZORG-NA.COM) for information on available adapters.