Owner`s manual

SECTION 1 - INSTALLATION

STEP 4: Assembling the Hose Protector

1. Place the hose into one half of the Hose Protector.

2. Place the other half of the Hose Protector over the hose ensuring that the male clip line up with the female clip.

3. Apply pressure to both halves of the Hose Protector until both pieces clip into place.

STEP 5: Positioning of the Hose Protector

The ideal positioning to t the Hose Protector is directly after the hose cuff.

Note: If the hose is connected directly to the Automatic Weir Valve (not advised), position the Hose Protector

approximately 10cm from the hose cuff.

IMPORTANT: Please note that the Hose Protector must be tted to the section of the hose connected to the

90° Elbow or Automatic Weir Valve (i.e. furthest away from the APC).

To Automatic

Pool Cleaner

(APC)

Male hose cuff

Automatic Weir Valve

Insert into weir

90° Elbow