User's Manual

SECTION 1 – INSTALLATION

STEP 3: Assembling the Hoses

1. Always insert the male hose

cuff into the female cuff. Hoses

must connect fairly tightly. The

ideal length of hose is from the

weir to the furthest point of

the pool plus one extra section

of hose. If the weir is opposite

the steps, use lowest step as

furthest point (See Diagram 3

and 4). To ensure the best

performance from your

ZODIAC G4™, please ensure

only genuine ZODIAC long life

hoses are used.

2. Attach your ZODIAC G4™ to the male end (smaller side) of the assembled

hose.

3. Fit the Hose Protection Mesh over the cuff of the hose to help prevent the

hose from wearing at the weir. Position the protection mesh so that ±10 cm

is exposed outside the weir.

4. Bleed all the air from the hose by placing one end over the return jet – thus

filling the hose length with water.

5. Keeping the hose-ends underwater, move it from the return line to the weir

and connect the female cuff directly to the Auto Weir Valve or utilize the 90°

Valve Elbow, depending on your weir configuration (See Diagram 5).

6. Ensure that the Auto Weir Valve is firmly attached to the weir vacum lid .

Diagram 3: Ideal Hose length

Diagram 4: Ideal Hose Length

Weir