Unit installation

1.4.3 Installing the appliance

 installed the 5 anti-vibration studs (supplied, see §1.1.2),

 put onto a stable, solid (concrete slab type) and level surface,

 preserve from risks of flooding due to condensation produced by the appliance whilst it is operating

(see §1.4.4)

1.4.4 Hydraulic connections

The connection shall be by Ø 50 PVC pressure pipe, from a by-pass , to the swimming pool filter

circuit, after the filter

 and before the water treatment :

Hydraulic circuit pressure

Fittings

= inlet

= outlet

Average water

flow-rate

head

loss

test operating

bar bar m³/h mCE

3 1.5

half union Ø50

fitting to stick

(see

parts  and 

§1.1.2)

3 1.3

4 1.4

11M

5 1.5

13M

6 1.5

15M

6.5 1.1

Water treatment, recommended parameters:

- free chlorine: maximum 2.5 mg/l,

- total bromine: maximum 5.5 mg/l,

- pH : between 6.9 and 8.0.

The water treatment system (chemical or electro-physical disinfection) must be installed

downstream from the heat pump (see installation below), and must be compatible

with it (check with the manufacturer).

Possibility of fixing the appliance to the ground, using the holes in the base of the

appliance.

A diagram of drilling is available to the back of the packing box.

Fixing holes