Install Instructions

MODELS 10-2614 AND 10-2615 “A-PAK” ALARM SYSTEMS WITH AUXILLIARY CONTACTS

WIRING INSTRUCTIONS

ELECTRICAL SHOCK HAZARD - Disconnect

all power sources before servicing. Failure to do so could result in

serious injury or death.

1) Remove the three screws from the back of the enclosure as shown in

Fig. H.

2) Remove the back of the enclosure. Note the position of the power cord

in the enclosure. The cord will need to be located in the same manner

when the enclosure back is replaced.

3) Determine the location where the auxiliary contact wires will enter the

housing. See Fig. I for recommended location. Before drilling the hole,

loosen the circuit board mounting screw and remove the circuit board.

See Fig. J.

4) At the selected location, drill a hole in the enclosure suitable for the

strain relief that will be used (strain relief not included).

5) Install strain relief and reinstall the circuit board. Connect wires to the

terminal block shown in Fig. J.

6) Markings on the circuit board show positions for Common (C), Normally

Open (NO), and Normally Closed (NC).

7) Position the power cord into place as it was prior to removing the

enclosure back as shown in Fig. J.

8) Reinstall the enclosure back and three screws.

Do not over torque screws. Screw bosses may

become stripped.

9) Note that while testing the installed product, the auxiliary alarm wired to

the auxiliary contacts should activate in an alarm condition. The auxiliary

alarm should also remain in alarm condition when the silence button is

pushed.

Auxiliary Contacts Specications

Voltage: 120 VAC

Current: 5 amps max. N/O

3 amps max. N/C

NOTE: This unit includes auxiliary contact option. Due to increased

power consumption, if an alarm condition occurs while on battery

backup power, this option will reduce the life of the battery.

SK2775

Figure H

Figure I

Figure J

All electrical systems must be installed by a qualied licensed electrician according to the

National Electrical Code and all other applicable codes.