Installation Instructions

AQUANOT

FIT FLOAT SWITCH

FIGURE 3

SK3186

FIT CONTROLLER FUNCTIONS

Therearetwobuttonsonthefrontofthecontroller.

- Silence/Reset

• Can be pressed to silence current alarms for 24 hours.

• Canbeheldforlongerthan3secondstoresetalarm.Resetwillclearashinglightonunit.

- Test

• Will run the pump to determine if amp draw of pump is in range.

• Controller is factory programmed to self-test the pump for several seconds every 24 hours.

• Pressing the test button will start the 24-hour timer for self-testing.

AQUANOT FIT

Solid Flashing Off

System Ready No Faults (Green)

ACoffwithnofaults

(Green)

Battery

Charged (Green)

Low Battery (Red) NoACPowerCharging (Yellow)

Bad Battery (Red)

DC pump Pump Ran (Yellow)

Pump Running (Yellow)

Pump Fault (Red)

Float Status High Water (Red) Float Fault (Red) --

Z Control Connected Searching BroadcastingSSIDorDormant

TheLEDswilldisplayinformationaboutthecontroller.

LOCKING PIN MUST BE

INSTALLED UNDER FLOAT

ROD IN THIS LOCATION.

MOLEX 4-PIN CONNECTOR

MOLEX 2-PIN CONNECTOR

FIG. 4

DC PUMP

DISCHARGE TEE

REDUCER FITTING

CLAMP

CHECK VALVE ASSEMBLY

CLAMP

SK2962

FIGURE 4