Installation Instructions

2. StandingneartheFit,useyourphone,tablet,orcomputertolookfortheFit’sSSIDinyourWiFisettings(seeFigureB).Itwilllooklike

“ZCTL_Fit_xxxx”where“xxxx”istherst4digitsofyourFit’sDeviceID.Selectthis,and2thingswillhappen:

1.TheZControl

LEDwillashquickly.

2.AZControl

setupscreen(SeeFigureC)willopenafterafewseconds.

If the setup screen does not appear, open a browser on the same device and type “192.168.125.1” in the address bar. If the setup screen

appears but is not used (cancelled or otherwise closed), the FitwillreturntoAPmodeandtheZControl

LED will turn off until the next

WiFi setup attempt.

3. Onthesetupscreen(seeFigureC),pressthe“WiFiScan”button,scrolldowntoseethelistofWiFisignalsfound,andchoosetheWiFi

youwanttheFittouseforinternetconnectivity.Enterthepassphrasefortherouteryouchoseintheeldindicated.Ifthepassphraseis

correct, the Fit will connect to the router and start sending status updates to zcontrolcloud.com. You will see the Z Control

LED go from

blinkingtosolid.Thiscouldtakeuptoaminuteorso.

IftheLEDdoesnotturnsolid,thenthepassphraseenteredisincorrect,therouter’ssecurityisinsufcient(seenotebelow**),orsome

othernetworkrestrictionisinplace(seeyournetworkadministrator).TheFitwillreturntostandbymodeiftheconnectiontorouteris

not successful. If you need to force the FitintoAPmodeagain,presstheZControl

buttonfor12seconds(SeeFigureA).Thiswillcause

theFittore-enterAPmodeandbegintransmittingitsSSIDagain.

ClickWiFiScanbutton

AvailableWiFiwillbelistedhere.

Selecttheoneyouwant.

**Note that the Fit will not connect to routers with “WEP” or “OPEN” security.

Figure C