Rp JIT Instruction Manual STAINLESS MUG Model Name of Each Part — —] Lid Cover ) Button 3 Stopper J Cover En Ug Safety Lock Stopper Gasket = Mouth ® Be sure that all parts are correctly placed or installed before each use. © The illustrations used in this instruction manual may differ from the actual product you have purchased. Please read these instructions before use, and keep fo future reference.
Important Safeguards ® Please follow these instructions to prevent scalding, deterioration and discoloration of beverages, as well as malfunction and staling of the Mug. Do not allow infants or small children to use this product. Keep out of the reach of infants and small children. Mishandling may cause injury or scalding. Always make sure that the Gaskets are attached during use. Contents may leak and cuss scalding or stains. Do not attach parts other than those specifically designed for this product.
Important Safeguards continued Do not fill with beverages while the Lid Set is attached. Doing so may causes beverages to overfill and may cause burning and scalding. Do not place near heat sources such as gas stoves, ovens and heaters. Doing so may cause deformation or discoloration of the Mug. Do not open the Lid Cover with the Mug close to your face or tilted toward you. Hot beverages may suddenly come out or spew out and may cause scalding. Do not drink out of the Mug while driving.
Warnings & Cautions Avoid dropping or hitting against hard surfaces. Damage to the plastic or stainless steel surface of the Mug may reduce its ability to retain heat. Clean the Milan Body after every use. Not cleaning thoroughly may cause the Main Body to rust, beverages to spoil, or cause pinholes. Do not remove the sticker on the bottom of the Main Body. Doing so may cause rust or holes.
#® Follow the instructions for care and wash the Lid Set, the inside and outside of the Main Body thoroughly before use. © When you first use the product, there may be a plastic smell. However, this will become less noticeable with use. "1 Remove the Lid Set from the Main Body. Remove the Lid Set from the Main Remove Body by muting it counterclockwise the Lid Set Lid as illustrated. L Set CRED Main Body a, 4 2 Fill the Mug with beverage.
How to Use: continued 5 Open the Lid Cover. Push the Button and release to open the Lid Cover. The Lid [eg ELEV) slightly. le =] UL] Push » "6 Drink the beverage. © Do not tilt the Mug suddenly when drinking. {The beverage may spill and cause scalding or stain clothes.) 7 Close the Lid Cover and lock. (D With the Mug at an upright position, close the Lid Cover until it clicks. @slide the Safety Lock all the way to the left to lock (see p.5 illustration 4). © Do not leave the Mug with the Lid Cover open.
How to Disassemble the Lid Set: continued 3 Remove the Lid Cover Gasket. Pinch the edge of the Lid Cover Gasket as illustrated and pull it toward you to remove. Lid Cover Gasket How to Assemble the Lid Set: © Be sure to attach the Stopper Cover Set, Lid Cover Gasket, Stopper and Stopper Gasket correctly to prevent malfunction or leaking of beverages. ’ 1 Attach the Lid Cover Gasket. ~ Small Align the Small Opening on the Lid = ALA Opening Cover Gasket with the protrusion on .
How to Take Care of 3 © Clean the product after each use to prevent odors and mold, and to keep the product sanitary. © Always disassemble the product before cleaning. (see (D Wash with warm water and mild dish washing liquid using a soft h B sponge. Main 1%, @ Rinse and then dry so there is no water left inside. ® To avoid damaging the nonstick coating, wash the liner of the Main Body using a soft sponge with a handle or a similar implement.
