RFE LJ Instruction Manual STAINLESS MUG Model SM-NAE Co Lid Cover Stopper Cover Stopper Gasket = Mouth ® Be sure that all parts are correctly placed or installed before each use. @ The illustrations used in this instruction manual may differ from the actual product you have purchased.
Important Safeguards ® Please follow these instructions to prevent scalding, deterioration and discoloration of beverages, as well as malfunction and staining of the Mug. Do not allow infants or small children to use this product. Keep out of the reach of infants and small children. Mishandling may cause injury or scalding. Always make sure that the Lid Cover, Stopper and Stopper Gasket are attached during use. Contents may leak and cause scalding or stains.
Important Safeguards continued ® Please follow these instructions to prevent scalding, deterioration and discoloration of beverages, as well as malfunction and staining of the Mug. When using a vehicle cup holder accessory: @ Always keep the Lid Set securely closed when not drinking. Beverage may spill if the Mug is tipped over, causing scalds or injury. @® Make sure the Mug fits into the holder securely before placing it in.
Avoid dropping or hitting against hard surfaces. Damage to the plastic or stainless steel surface of the Mug may reduce its ability to retain heat. Clean the Main Body after every use. Not cleaning thoroughly may cause the Main Body to rust, beverages to spoil, or cause pinholes. Do not remove the sticker on the bottom of the Main Body. Doing $0 may cause rust or holes. 5) Do not damage the nonstick coating Inside the Main Body. Scratches may cause rust, holes or other problems.
® Follow the instructions for care and wash the Lid Set, the inside and outside of the Main Body thoroughly before use. ® When you first use the product, there may be a plastic smell. However, this will become less noticeable with use. ’ 1 Remove the Lid Set from the Main Body. Remove the Lid Set from the Main Body by muting it counterclockwise as illustrated. 2 Fill the Main Body with beverage, and then close the Lid Set.
How to Disassemble the Lid Set: continued 2 Remove the Stopper. Remove the Stopper by muting it in the direction of the arrow, until {on the Stopper aligns with the \/ mark on the Stopper Cover. ® When doing so, please hold the Stopper Cover and Lid Cover securely so the Lid Cover does not come off the Stopper Cover. Stopper Cover 3 Remove the Lid Cover. Remove the Lid Cover from the = Stopper Cover. @ Phe ch ae If the Stopper does not tur The Lock may not operate properly if clogged.
How to Assemble the Lid Set: continued # 2 Attach the Lid Cover. Attach by aligning the Recess in the Stopper Cover with the Ridge on the Lid Cover. 3 Attach the Stopper to the Stopper Cover. @ Match fH on the Stopper to the <7 mark on the Stopper Cover and insert the Stopper into the Stopper Cover. @ Tum until {} reaches the [| mark. ® When doing so, please hold the Stopper Cover and Lid Cover scurvily so the Lid Cover doss not cons off the Stopper Cover. Align {} with the mark.
How to Take Care of g @ Clean the product after each use to prevent odors and mold, and to keep the product sanitary. @® Always disassemble the product before cleaning. (see N (D Wash with warm water and mild dish washing liquid using a soft Exterior sponge. K Abet @ Rinse, shake a few times and wipe dry. Lid Set ® When washing the Lid Set, disassemble it first then wash and dry. ® Use a small brush sold in stores if necessary.
