User manual

Basic Configuration
WAN Setting
This page allows you to specify how the WAN port of the router connects to your ISP’s
server. There are four types of connection ways for you to select from. Please choose your
connection mode from the drop-down list as required by your ISP. The default setting is
PPPoE.
PPPoE
PPP over Ethernet is a protocol for connecting remote hosts to the Internet over an always-on
connection by simulating a dial-up connection. With PPPoE the client does not set a static IP
address, instead an IP address is assigned dynamically whenever the client access to the
Internet. If PPPoE connection type is selected, please configure these parameters:
User ID/Password: Enter the User ID and Password provide by your ISP to access the
remote host.
Connection Type:
Dial On Demand: If checked, under disconnected status, if any client PC sends out request
for connection, the Broadband Wireless Router (AP) will dial the ISP automatically. In this
case, if the system administrator wants to disconnect the PPP session, just click the
Disconnect button.
Keep Alive: When enabled, a PPP session will always keep on line.
Manual: This button allows you to manually launch or terminate the PPP session. For instant
connection, just click the Connect button. The connection will be established instantly
without having to restart the device or click the Apply button. To disconnect the PPPoE
session, just click the Disconnect button.
Max Idle Time: This value specifies the idle minutes that elapse before the device
automatically disconnects the PPP session. If no traffic is passing through during the span of
time your specified, the PPP session is terminated.
IP Address/Subnet Mask: Displays the IP address and the subnet mask the device gets after
the connection is established. Clicking Refresh will refresh the information.
23