UTR-20 Assembly Instructions

• Remove the 5/16” bolts, flat washers and Nylock nuts from the hardware bag and insert them through the

top rail U-brackets as shown in Diagram 4b and tighten enough to keep the rails from sliding on the

canisters.

Step 5: Mounting the Tracker on the pole:

NORTH

SOUTH

Diagram 5

• On the gimbal can that is mounted to the axle assembly, make sure to loosen the set bolt to allow enough

space for the mounting pole to slide inside.

• While holding the top rail firmly in place against the north end of the axle assembly, lift the tracker atop the

pole.

• When you lift the tracker off of the ground allow the axle assembly to rotate downward as shown in

Diagram 5.

• Lower the gimbal can onto the pole and tighten the set bolt. This may distort the gimbal can a slight bit, but

that is normal. Make sure not to cross thread the set bolt as this will allow the tracker to spin atop the pole.

For added protection against spinning, the installer could pre drill a ½” hole in the mounting pole for the set

bolt to slide into.