UTR-20 Assembly Instructions

Step 3: Attaching the Axle Assembly:

NORTH

SOUTH

Diagram 3

• Remove the Axle Assembly from the box. The axle assembly will have the shock and bumper bolt taped to

the bent rod. There is no need to remove them as it will make this step more difficult. The shock is also

already pre-attached to the bent rod and secured with a cotter-pin.

• Remove the shaft-collar and slide over the end of the axle and as far up as possible and lightly secure with

the provided 5/32” Allen Wrench.

• With the axle assembly in the position shown slide the axle through the bearing on the bottom rail until the

bearing comes in contact with the shaft collar. It may be necessary to wiggle the axle as you slide it through

the bearing.

• The Gimbal can also come pre-attached; it is not necessary to remove it.