User Manual

10
• Turn off the Zonar 2010’s power
- Press Power button
• Return the Zonar 2010 to its vehicle mount between trip inspections
- Transmit Completed Pre/Post-trip Inspections To Zonar Systems
• Place Zonar 2010 into Reader Downloading Station (RDS)
WHEN: THEN:
The inspections reports are being transmitted • The light on the cradle changes from
green to red
• The screen shows: ‘Downloading…’
The light on the cradle is red Don’t remove the Zonar 2010 from the cradle
The light on the cradle changes from red to green The transmission is complete and you can
remove the Zonar 2010 from the cradle
Charge The Zonar 2010’s Batteries
Place the Zonar 2010 into its vehicle mount (connected to the 12V power using a cigarette
ighter adapter or wired directly to the electrical system)
Note: While the Zonar 2010 is in its vehicle mount or RDS, the CHARGING indicator light will be
a steady green. When the batteries are fully charged, the CHARGING light flashes green. While
the time to fully charge the batteries varies depending upon the beginning battery level, it typically
takes four hours to fully charge the batteries.
The Store Report screen
appears after you’ve inspected
all the zones
The Store Report screen
appears after you’ve inspected
all the zones
The Incomplete Report screen
appears after selecting Store
Curr Report from the Main Menu
The Incomplete Report screen
appears after selecting Store
Curr Report from the Main Menu
Press the green Y (yes) button
Press the red N (no) button
Note: You’ll return to the Zones
screen and can make changes
• Press the red N (no) button
• Go back and inspect the missing
components
• Follow directions for storing the
current report
Press the green Y (yes) button to
make a permanent record of the
incomplete report
Note: An incomplete report is
recorded as BAD on the Report
History screen
You’re ready to make a
permanent record of the
inspection report
You’re not ready to make a
permanent record of the
inspection report
You want to go back and
complete inspecting the missing
listed zone(s)
You don’t want to go back and
complete inspecting the missing
listed zone(s)
• Store the current report
IF: AND: THEN: