User's Manual

OPERATION &
TROUBLESHOOTING
8
Post Install Checkout:
1) Start vehicle for one minute to establish GPS and Cellular connections
2) Reader LED should now be a steady blue to indicate the reader is ready to accept card scans
3 Scan card - Reader will 1X blink green and beep once to acknowledge a successful card scan
4) Reader LED will return to a solid blue state to indicate it is ready for additional scans
5) Verify successful card scan in Zonar's web based "ZPass" program. Customercode.zonarsystems.net/zpass or
customercode.zonarsystems.net and go to the home tab the go to ZPass.
Volume Control Button:
1) Only works with external speaker. It does not change the volume level of the internal speaker.
2) Pushing the volume control button cycles through 4 available volume levels.
Color State Description Notes
Blue Solid Ready to scan cards
Green 1X Blink & Successful card scan Rescan of the same card requires 15 seconds
Audible Beep between consecutive scans
Red 2X Red SD memory card missing or error Reinsert or reseat SD card
blinking LED
Red 1X blink Synchronizing time If continuous, see Troubleshooting Section (page 9)
Solid Card reader disabled - occurs when
vehicle speed is greater than 25 mph
Orange Solid Receiving Firmware update This takes approximately 3 minutes
Operation