User's Manual

10
Switch Select
Swashplate Type
Switch Select
Trim Step
The Switch Select function allows the switches, knob and
right and left trimmers to be assigned to the gear, Aux1,
Aux2 or Aux3 channels or inhibit.
Press and hold the roller while turning on the transmitter.
When System Setup appears on the screen, release the
roller. The AH6T is now in System Setup Mode.
The Switch Select function allows the switch, knob, right
and left trimmers, hold, throttle curve.
To Program the Switch Select Functions
Press and hold the roller while turning on the transmitter.
When System Setup appears on the screen, release the
roller. The AH6T is now in System Setup Mode.
Rotate the roller to highlight the desired switch, knob or
trimmer then press.
Select the channel or function you wish to assign. See
chart for options. Press the roller to accept. Note that a
channel or function can only be assigned once.
Repeat to select all desired switch positions.
The Trim Step function allows servo movement
adjustment per click of trim. For example you usually want
a large trim step (8 to 10) for a new model. Each click of
trim will have a large amount of trim travel so you can
quickly adjust an out-of-trim model in flight. Later you can
use a finer trim step (1-5) to adjust for precise flight. The
Trim Step function allows the trims to be common or
independent in each active flight mode. Many helicopter
pilots use independent trims because they are
automatically active when a flight mode is activated.
Important: The trim step function has no effect on the
overall trim travel, only the total number of clicks
available. If you select a 0 value in trim step, the trim is
turned off.
To Access the Trim Step Function
Press and hold the roller while turning on the transmitter.
When System Setup appears on the screen, release the
roller. The AH6T is now in System Setup Mode.
Rotate the roller to highlight the desired switch, knob or
trimmer then press the roller to access.
Rotate the roller to select the desired channel or function
you wish the switch, knob or trimmer to operate. Press the
roller to accept. Note that the channel or function can only
be assigned once.
Repeat to select all desired switch positions.
Use the Swash Type screen to program the swashplate
mix to match your helicopter swashplate type. Six
swashplate types are available: Normal, 3-servo 120
CCPM, 3-servo 140 CCPM, 3-servo 90 CCPM, 3-servo
135 CCPM, and 2-servo 180 CCPM. Select the correct
swashplate type to match the specific helicopter before
doing any other cyclic programming e.g., Pitch Curve,
Travel Adjust, Sub-Trim, etc.). If in doubt consult your
helicopter’s manual for correct swashplate mixing.
Rotate the roller to highlight Swash Type then press the
roller to access the function. The following screen
appears:
Highlight the current swashplate type then rotate the roller
to select the desired swashplate mix. When the desired
Swashplate mix is displayed press the roller to select. In
Systems Settings highlight User Name then press the
roller to select that function. Select the desired mode then
press to accept.
To Access the Swash Type Function