User's Manual

Servo.Travel

Servo Speed & Trim

D/R & Exponential

To Access the Servo.Travel

To Access the Servo.Speed&Trim

To Access the D/R and Expo Function

Rotate the roller to highlight Servo.Travel then press. The

following screen appears:

Then the following screen appears:

Rotate the roller to the channel you need to setup then

press.

after that rotate the roller to adjust the parameter.

Rotate the roller to highlight Servo.Speed&Trim then

press. The following screen appears:

Then the following screen appears:

Rotate the roller to the channel you need to setup then

press after that rotate the roller to adjust the parameter.

Dual Rates and exponentials are available on the aileron,

elevator and rudder channels. You can assign them to

numerous switches including the flight mode switch.

Dual Rate

Affects the overall travel which in turn affects control

response sensitivity equally throughout the range of that

channel. Reducing the dual rate reduces the maximum

control rate as well as overall sensitivity.

Exponential

Affects the sensitivity around center but has no affect on

the overall travel. Positive Exponential reduces control

sensitivity around neutral for more precise control but

does not affect the maximum control response.

Note: Positive and negative exponential values are

available. A positive expo value reduces control sensitivity

around center. It does not affect maximum travel and is

recommended. Negative exponential values increase

sensitivity around neutral and is seldom used.

Rotate the roller to highlight D/R and Expo then press to

access.

To Select a Channel

Highlight the channel then press the roller to access.

Rotate the roller to select the aileron, elevator or rudder

channel. Press to accept.