User's Manual

17
Throttle Cut Throttle Curve
Throttle Curve
The Throttle Cut function allows you to shut off an engine
with the Trainer switch, Gear switch or the Right or Left
trimmer. When you activate the programmed switch, the
throttle channel is driven to it’s preprogrammed value
normally off. This effectively kills the engine. Release the
programmed throttle cut switch/trimmer, and normal
throttle operation resumes.
To Activate Throttle Cut and
Assign it to a Switch or Trimmer
Rotate the roller to highlight Throttle Cut then press to
access the Throttle Cut screen.
Highlight Inhibit then press the roller to access the switch
options.
Rotate the roller to the desired switch to cut the throttle
(Trainer, Gear, Mix , L trim or R trim) then press the roller
to program that switch.
Program a Throttle Cut position. Note that 0%= low
throttle, mid trim and negative values are available. To test
the Throttle Cut function, activate the programmed switch.
Note the throttle servo position or the position of the
throttle channel in the servo monitor. The system should
drive the servo position to the low throttle position when
you activate Throttle Cut.
The Throttle Curve function allows throttle output vs. input
positions to be adjusted. This is typically used to alter the
throttle response to give a linear rate or to adjust the
throttle response sensitivity when hovering or torque
rolling. You can program a single curve (switch to On) or
up to three curves and select them via a programmed
switch. The screen displays a graphic 5-point throttle curve
on its left side to aid in selecting throttle curve values. An
Expo function is available that smoothes out the Throttle
curve.
To Program the Throttle Curve Function
With the transmitter on and the main or telemetry screen
displayed, press the roller. The Function list displays
Rotate the roller to highlight Throttle Curve then press the
roller to access the Throttle Curve screen.
With the switch listed at the bottom of the screen in the
position desired for this curve, rotate the roller to highlight
one of the five available throttle curve values (Low, 25%,
50%,75, High). Press the roller to access.
To Activate the Expo Function
Rotate the roller to highlight EXPO then press the roller to
access the Throttle Curve Expo function. Select Inh or Act to
inhibit or activate the Expo function then press to accept.
The AH6T features a 5-point throttle curve. You can assign
up to four separate throttle curves. A graph displays at the
left side of the screen to aid in adjusting throttle curves. An
Expo function is also available that smoothes out the curve.
To Program Throttle Curves
With the transmitter on and the main or telemetry screen
displayed, press the roller. The Function list displays.