User's Manual

18
Flap System
To Activate the Flap Function
To Select a Switch
Setting Flap and Elevator Positions
Selecting a Flight Mode
Adjusting the Curve
To Activate the Expo Function
Rotate the roller to highlight Throttle Curve then press to
access that screen.
Highlight the desired flight mode at the top of the screen
then press the roller to select. The selected flight mode
will darken confirming your selection.
N= Normal / 1= Stunt 1 / 2= Stunt 2 / H= hold
Move the flight mode switch in the position you wish to
adjust. Rotate the roller to highlight one of the five
available throttle curve values (Low, 25%, 50%, 75%,
High). Press the roller to access that value.
Rotate the roller to adjust the selected point to the
desired output position. Note the position on the graph at
the left of the screen.
Repeat this for all desired points.
Rotate the roller to highlight EXPO then press to access
the Throttle Curve Expo function. Select Inh or Act to
inhibit or activate the Expo function. Press the roller to
accept.
The AH6T flap system offers up to three programmable
flap and elevator positions (normal, mid and land). You
can assign them to a variety of switches. You can
program a Speed function to slow flap and elevator
compensation travel for a scale effect. A graphic display
on the left side of the Flap System screen provides a
visual display of servo position aiding in setting up and
adjusting the flaps.
Notice: The Flap function is only available on wing types
with flaps.
With the transmitter on and the main or telemetry screen
displayed, press the roller. The Function list displays.
Rotate the roller to highlight Flap System then press.
The Flap System defaults to Inhibit. To activate the Flap
System, rotate the roller to highlight Inhibit then press to
access the switch function. Rotate the roller to the
desired Flaps control switch. Press to access that screen.
Rotate the roller to select desired Flap positions value
then press the roller to
access that value. Now rotate to adjust the flap position
value. Note: it is recommended that the flap switch
position match the flap adjustment that
is being adjusted. This will allow you to observe the
effects of the flap adjustment.