User's Manual

Pitch Curve
To Program Pitch Curves
Selecting a Flight Mode
Adjusting the Rate Values
Rotate the roller to the parameter you need to setup then
press. Adjust the parameter, Repart this to set all
parameter.
The AH6T features a 5-point Pitch curve. You can set up
to four separate Pitch curves. A graph displays at the left
side of the screen to aid in adjusting pitch curves. An
Expo function is available that smooths out the curve.
With the transmitter on and the main or telemetry screen
displayed, press the roller. The Function list displays.
Rotate the roller to highlight Pitch Curve then press.
Highlight the desired flight mode at the top of the screen.
Press the roller to select. The selected flight mode will
darken to confirm the selection.
N= Normal / 1= Stunt 1 / 2= Stunt 2 / H= hold
Adjusting the Curve
Move the flight mode switch in the position you wish to
adjust. Rotate the roller to highlight one of the five
available pitch curve values (Low, 25%, 50%,75%,
High). Press to access that value.
20
Rotate the roller to adjust the selected point to the desired
output position. Note the position on the graph at the left of
the screen.
Repeat this for all desired points.
To Activate the Expo Function
Highlight EXPO then press the roller to access the Pitch
Curve Expo function. Select Inh or Act to inhibit or activate
the Expo function. Press the roller to accept.