User's Manual

Swashplate Mix
The Swashplate Mix typically corrects swashplate timing
issues by mixing Aileron to Elevator and Elevator to
Aileron. When adjusted correctly, the Swashplate causes
the helicopter to roll and pitch accurately with minimal
inter-reaction.
To access Swashplate Mix
With the C Mix screen displayed, rotate the roller to
highlight Cyclic > Thro then press. Select Swashplate
and press the roller. The Swashplate Mix screen
appears.
Adjusting Swashplate Rates
Rotate the roller to highlight the desired rate then press.
Rotate the roller to adjust the value. You can reverse the
direction of the slave channel with positive + and
negative – values. Adjust the rate for all desired
Swashplate values.
Programmable Mixes
To Access Programmable Mixes (1 thru 6).
With the C Mix screen displayed, rotate the roller to
highlight Cyclic > Thro, then press the roller. Select
programmable Mix, 1, 2, 3, 4, 5, or 6 and press the roller.
The Mix screen appears.
To Select Master and Slave Channels
The Master channel is the controlling channel and is
mixed to the slave channel. The slave channel follows
the master channel’s input based on the rate that is
programmed.
Rotate the roller to highlight the left INH then press to
access the master channel. Select the desired master
channel. Press the roller to accept.
To Select the Switch
Rotate Roller to highlight "SW", and the switch.
Adjusting Programmable Mix Rateas
Rotate the roller to highlight the desired rate then press.
Rotate the roller to adjust the value. You can reverse the
direction of the slave channel with positive and negative
values. Adjust the rate for both directions/values.
You should verify that the programmable mix is working
properly and in the correct direction. Place the flight
mode switch in one of the active positions.
Move the programmed master channel while observing
the slave channel. The slave channel should move
accordingly.
Offset
The Offset function establishes the point at which the two
mix rates converge. Typically, this rate is center or 0%. If
an offset is needed (normally not in a helicopter), do the
following.
Programming an Offset
Rotate the roller to highlight Offset then press. Rotate the
roller to adjust the value. Positive + and negative - values
shift the offset in either direction. Press the roller to
accept.
Trim Include
The trim include function applies trim to the slave
channel when the selected master channel has trim
(throttle, aileron, elevator and rudder). Typically this is
used when more than one channel operates a primary
control surface (dual aileron servos, etc.) With trim
23