User's Manual

Timer
Program AUX
include activated, the master channel’s trim affects the
slave channel’s trim as well.
Activating Trim Include
Rotate Roller to highlight Trim then press to select INH or
ACT.
AUX0 , 1 can customize the output of 10 different states.
Notice : Priority output low position.
To access the Program AUX Function
Rotate the roller to highlight Program AUX then press.
The following screen appears:
Rotate the roller to the channel you need to setup then
press.
Rotate the roller to the channel you need to setup then
press.
Rotate the roller to the channel you need to setup then
press.
after that rotate the roller to adjust the parameter.
Rotate the roller to the switch you need to ues then
press,after that select the relevant switch.
The AH6T Timer function allows you to program a Count
Down timer or Stop Watch (count up timer) to display on
the main screen. An alarm sounds when the programmed
time is reached. You can program the timer to start using
the trainer switch, the left or right trimmers or
automatically when throttle is raised above a
preprogrammed position. Also, an internal timer that
shows run time for a specific model displays on the main
screen.
To access the Timer Screen
With the transmitter on and the main or telemetry screen
displayed, press the roller. The Function list displays.
Rotate the roller to highlight Timer then press.
Rotate the roller to highligh Timer then press, and enter
the function screen.
To select the Timer Mode- Inhibit, Count Down or Stop
Watch. Highlight Mode then press.
Rotate the roller to select the Timer which you want then
press, and enter the function screen.
24