User's Manual

Neutral
Monitor
sA
To Program a Time
Rotate the roller to highlight Time then press to access.
You can highlight the seconds or minutes. Press the roller
to access minutes or second.
Rotate the roller to select the desired time. Press to
accept.
To program a Tone, Vibe, Tone/ Vibe or Inhibit
Rotate the roller to highlight Tone then press to access. You
can Select Inh. Tone, Vibe or Tone /Vibe
To Select the Timer Start Method
Rotate the roller to highlight Start then press to access. Five
start options are available: Trainer switch, Throttle, Throttle
1-Time, L Trim and R Trim.
Throttle 1-time - The timer starts when the programmed
throttle position is exceeded and will continue regardless of
the throttle position.
Throttle - The timer starts when the programmed throttle
position is exceeded. Anytime you lower the throttle below
the programmed position, the timer will pause then continue
anytime the throttle is raised above that position.
Rotate the roller to select the mode need to activate then
press.
Programming a Throttle Stick Position-
Only if Throttle Start is Selected
If you select Throttle or Throttle 1-Time in the Start function,
the Stick appears below Start in the Timer screen. This is the
stick position where throttle activates the timer. Rotate the
roller to highlight Stick then press to access the Stick values.
You can adjust the value from 0 to 100%. This correlates to
the actual throttle stick position.
Rotate the roller to select the desired Stick value then press
the roller to accept the displayed value.
Rotate the roller to select the desired Stick value then press
the roller to accept the displayed value.
There are a couple of ways to reset the internal timer. Rotate
the roller to highlight Internal: Reset then press the roller to
reset the internal timer to 0:00:00
To reset the Count Down or Stop Watch timer on the main
screen, press the Clear button.
The Monitor screen displays the servo positions for each
channel graphically and numerically. This is useful to verify
programming functions, trim settings, mix directions, etc. The
numeric value is directly relative to the travel adjust and mix
values (e.g., 100% travel adjust equals 100% value in the
Monitor).
To Access the Monitor screen
With the transmitter on and the main or telemetry screen
displayed, press the roller. The Function list will display.
Rotate the roller to highlight Monitor then press to
access.
After enter the screen, rotate the roller to test the servo.
25