User's Manual

Mode Changes

MODE 1

Rudder Stick Aileron Stick

MODE 2

MODE 3 MODE 4

Elevator Stick

Throttle Stick

Elevator Stick

Throttle Stick

Elevator Stick

Throttle Stick

Rudder StickAileron Stick Rudder StickAileron Stick

Rudder Stick Aileron Stick

The AH6T can be easily converted to mode 1, 2, 3, or 4. This conversion requires a mechanical and a programming

change. (Stick and switch positions for mode 1 and 2 are illustrated on pages 8 and 9.) Following are detailed instructions

on making mode changes.

Mechanical Conversion

Mechanical conversion is required to switch between modes 1 and 2 or between modes 3 and 4. The centering spring for

elevator and the friction straps for throttle must be engaged on the appropriate gimbal and throttle limiting wedges must

be swapped.

Step 1. Carefully pull back the rear grips and side rubber panels and unscrew the A,B,C,D,E and F head screws shown.

Step 2.

Left Throttle to Right Trottle (Mode 2 / Mode 4 to Mode 1 / Mode 3)

i) Use a cross-drive screw driver to loosen Screw A. Keep loosening until the stick can move up and down without friction.

ii)

Tighten Screw B. Keep tightening until the stick can move up and down with rebounds.

iii)

Loosen Screw C. Keep loosening until the stick can move up and down without rebounds.

iv)

Tighten Screw D. Keep tightening until the stick can move up and down with friction.

Right Throttle to Left Trottle (Mode 1 / Mode 3 to Mode 2 / Mode 4)

i) Use a cross-drive screw driver to loosen Screw D. Keep loosening until the stick can move up and down without friction.

ii)

Tighten Screw C. Keep tightening until the stick can move up and down with rebounds.

iii)

Loosen Screw B. Keep loosening until the stick can move up and down without rebounds.

iv)

Tighten Screw A. Keep tightening until the stick can move up and down with friction.

Step 3. When satisfied with the stick tension, reinstall the grips and rubber plugs.