User's Manual

Adjustable Stick Tension
MODE 2
Elevator
Aileron
Throttle
Rudder
Programming Conversion
When making a mode conversion, the programming must also be changed and when changing throttle elevator
positions the transmitter must be recalibrated in the systems setting screen.
Adjustable Stick Length
The AH6T allows you to adjust the control stick’s length. Use the included 2mm Allen wrench to loosen the setscrew by
turning it counterclockwise. Then, turn the stick clockwise to shorten or counterclockwise to lengthen. After adjusting the
control stick length tighten the 2mm setscrew.
The AH6T offers adjustable tension on the throttle, aileron, elevator and rudder sticks. Rubber plugs are installed in the
back of the case allowing easy access to the stick tension screws without having to remove the back case.
To adjust stick tension:
To Access the System Settings Function
Highlight System Settings then press the roller to access
the System Settings function. The System Settings
screen will appear.
When changing modes that swap throttle and elevator
positions it’s necessary to recalibrate the sticks. When the
mode change is programmed, the calibration screen will
automatically appear the next time the transmitter is turned
on and the following screen appears:
To calibrate, move the sticks throughout their range then
back to center including the throttle. Once all sticks have
been centered, press SAVE to complete calibration.
Step 1. Remove the two rubber plugs and pull back the grips as shown to access the
throttle, aileron, elevator and rudder tension screws.
Step 2. Using a Phillips screwdriver, adjust the stick tension screw for the desired
control. Clockwise to tighten and counterclockwise to loosen.
Step 3. When satisfied with the stick tension, reinstall the grips and rubber plugs.
27