User guide

Appendix B Regulatory Compliance Information

Radio Frequency Interference Requirements

This device complies with Part 15 of FCC Rules and Canada RSS-210.

Operation is subject to the following conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may cause undesired

operation.

3. To comply with RF safety requirements, you must maintain a distance of 20 cm from the antenna when

operating the device.

4. This transmitter must not be co-located or operating in conjunction with any other antenna or

transmitter.

5. Since the module is installed inside the end product, a label showing that the product contains a RF

module should be affixed on the end product in a visible area. This label should also show the FCC

ID.

Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules; these limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses, and can radiate radio frequency

energy. Thus, if it is not installed and used in accordance with the instructions, it may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television

reception,( which can be determined by turning the equipment off and on), the user is encouraged to try

to correct the interference by one of the following measures:

◆ Reorient or relocate the receiving antenna.

◆ Increase the separation between the equipment and receiver.

◆ Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

◆ Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: To assure continued compliance, (example – use only shielded interface cables when

connecting to computer or peripheral devices). Any changes or modifications not expressly approved by

the party responsible for compliance could void the user’s authority to operate this equipment.