User manual

- 12 -
3.3 IP Address Configuration
You have to check the IP address of your computer if you failed to access the ZVC7610W.
When connecting the ZVC7610W directly to your computer, you have to set up your
computer IP address within the same subnet in order for them to communicate correctly.
1. On your computer, click Start > Control Panel to open the Control Panel window
2. Double-click Network Connection to open the Network Connection window
3. Right-click Local Area Connection and click Properties, then select the General tab
4. Select Internet Protocol [TCP/IP] and click Properties to bring up the Internet
Protocol [TCP/IP] Properties window
5. Configure a fixed IP address that is within the same subnet of the ZVC7610W. Select
Use the following IP address option and enter an IP address and Subnet Mask into
the empty field, for example: IP Address is 192.168.0.x where x is between 0~254
except 30 and Subnet Mask is 255.255.255.0.
6. Click OK after you finish.