Operation Manual

- 3 -
Operation
The fur to be cut must be dry and clean. Brush the
fur through to remove any knots.
t 
3FNPWFUIFCMBEFHVBSE7 from the cutting
head 
.
t Place the required trimming guide (1 - 6)
with the prongs facing upwards on the cutting
head  and thereby press the flap of the trim-
ming guide down firmly onto the lower metal
edge of the cutting head (see illustration).
t &OTVSFUIBUUIFUSJNNJOHHVJEFIBTQSPQFSMZ
engaged and is secured before starting to cut/
trim the fur.
Note:
It is advisable to first trim a small area so as to test
the individual comb attachments. Start with a comb
attachment for long hair (1/2“
4
or 3/8“
3
)
and, if necessary, use a shorter one. The comb
attachments permit cutting lengths from 3 to 13 mm.
t 
Switch the appliance on by sliding the On/Off
switch UPUIFQPTJUJPOv0/i
t 4MPXMZSVOUIFBQQMJBODFUISPVHIUIFGVSBHBJOTU
the direction of hair growth. Hold the appliance
so that the trimming guide is as flat as possible
against the animal.
t

In addition, with the adjustment switch

the
cutting length of the cutter head

can be
adjusted in steps(up to 2 mm) without having
to exchange the comb attachment. To do this,
slide the adjustment switch

backwards to
increase the cutting length in steps. With this the
cutting length of the respectively attached comb
attachment is also increased by up to 2 mm.
Slide the adjustment switch

forward again to
reduce the cutting length or to bring the comb
attachment back into its original position.
t

Through removal of the individual trimming
guide, i.e. using only the cutting head

itself,
you can cut clean contours.
t

After use, switch the appliance off by sliding the
On/Off switch

to the position „OFF“.
Cleaning and Care
Risk of electric shock!
Before cleaning, remove the plug from the mains
power socket.
/&7&3TVCNFSTFUIFBQQMJBODFJOXBUFSPSPUIFS
liquids.
t 5BLFUIFSFTQFDUJWFUSJNNJOHHVJEFJGmUUFEPé
t 
Using exclusively the cleaning brush 8, remove
the hairs from the cutting head 
. The cutting
head

may not be cleaned with water or
PUIFSMJRVJETFYDFQUNFEJDBMBMDPIPM
t 
If in regular use, the cutting head  should be
oiled occasionally. For this, use the supplied
blade oil 9
.
t 3FNPWFFYDFTTPJMXJUIBESZDMPUI
t $MFBOUIFIPVTJOHXJUIBTPGUESZMJOUGSFFDMPUI
t Store the appliance in a dry and dust free
location. When it is in storage, place the blade
guard
7
on the cutting head

.