User's Manual

Appendix B: Front and Back Panels
115
Appendix B
Front and Back Panels
The following table describes each LED on the front panel.
LED Description
POWER
Green when the X6v is plugged into a power source.
Red when a self test error is found.
ETHERNET
Lights if any Ethernet port of the
X6v is plugged into the
Ethernet port of a powered-up device. Blinks when data
is sent.
Additional lights for each Ethernet port are on the back
of the
X6v.
WLAN
Lights when the Wireless Local Area Network is running
and enabled. Blinks when data is sent.
DSL
Blinks when the
X6v is performing its startup sequence.
Steady on when the unit has synched up with its DSL
connection.
Note: If the light fails to switch from blinking to steady
after a minute or two, check with your DSL provider that
the DSL connection is activated, or refer to Appendix D,
Troubleshooting on page 125.
INTERNET
Steady green when an Internet connection is
established.
Blinks green to indicate data activity.
Red when the X6v cannot access the Internet.
Off when the X6v is in Bridge mode, or if there is no
DSL connection.