User's Manual

Chapter 1: Installation Instructions
14
Establishing Communication
Important!
Macintosh and Linux users must make sure that the computer’s
TCP/IP settings are configured properly BEFORE starting this
section. See Macintosh TCP/IP Settings on page 119 or Linux
TCP/IP Settings on page 121 for instructions.
You must set up the X6v so that it can communicate with your
Internet service provider. To do this, you use the Zoom
Configuration Manager.
1 Close all programs including antivirus software and pop-up
blockers.
2 Log into the Zoom Configuration Manager:
a Open your Web browser and, in its address bar, type
http://10.0.0.2 and then press the Enter key on your
keyboard.
In the Enter Network Password dialog box, type the
following user name and password in lowercase, then click
OK. (The X6v User Name and Password you enter here
are not the same as the User Name and Password that
your Internet service provider may have given you.)
User Name: admin
Password: zoomDSL