User's Manual

Chapter 6: Using Advanced Setup
69
Setting Description
IP Address, Subnet
Mask, Default
Gateway, and DNS
If you are using a Static IP address, enter
the values for IP Address, Subnet Mask,
Default Gateway, and DNS server that
your service provider gave you. You must
also be using the 1483 protocol.
Ethernet Filter Type
Specifies the type of Ethernet filtering that
is performed by the bridge interface. All-
Allows all types of Ethernet packets
through the port. Ip-Allows only IP/ARP
types of Ethernet packets through the port.
PPPoE-Allows only PPPoE types of
Ethernet packets through the port.
ATM
Traffic Class
Peak Cell Rate
Burst Tolerance
Max Cell Rate
Max Burst Rate
Sustainable Cell
Rate
These settings allow you to give priority to
data that is sent over the network.
Important! You must make arrangements
with your DSL provider to use anything
except UBR (Unspecified Bit Rate) in the
Traffic Class setting. Your service provider
will also supply you with the Cell, Burst,
and Tolerance Rates.