User's Manual

Chapter 6: Using Advanced Setup

Here is a picture of the Static Routes page:

The following table describes Routing Table settings. If you change

any of the settings, click Add, and then Write Settings to Flash.

Setting Description

Existing Routes

This table shows the existing Static routes

set up on your DSL Modem.

Destination Enter the subnet IP address of the

destination.

Gateway Enter the Gateway IP address of your

destination’s subnet. The HOP gateway

must be on the same subnet as the

modem.

Mask Enter the subnet mask (range of IP

addresses) of the destination IP addresses

based on the above subnet IP address of

the destination.

Metric

The number of hops. This should usually

be left at 1.

Advertise

Enable this if you want to advertise this

route.