User's Manual

Chapter 6: Using Advanced Setup

Here is a picture of the DSL Configuration page where you change

your settings:

The following table shows you the values to enter. After you enter

the values, click Save Changes, then Write Settings to Flash.

Setting Description

BitSwap

Enables or disables bit swapping in both

upstream and downstream directions. If you

experience frequent connection drops, it may

help to change the bit swap settings.

BitSwapUp

Enables or disables upstream bit swapping.

Standard

If you are having problems establishing the

physical layer connection, you can try selecting

different settings to see if this helps you connect.

(If the INTERNET light on the modem is blinking

then the physical layer connection is down; if the

INTERNET light is steady on, then the problem is

elsewhere.) The default is DSL2PlusAuto.

EC/FDM Mode

If you are having problems establishing the

physical layer connection, you can try changing

this value to EC.

Activate Line Select None if there are no changes to the

current mode.

Select Abort if you want to stop the modem from

connecting. The status will show up as idle on

the DSL Status page. Select Start to restart the

connection.