User's Manual

錯誤 ! 尚未定義樣式。 User’s Guide Advanced DSL port attributes
106
D Advanced DSL port attributes
The following table displays detailed information about the
advanced DSL port attributes. These attributes are displayed on the
Port A1 Advanced Configuration page (part 1) and Port A1
Advanced Configuration page (part 2).
Note
You should only need to refer to these attributes if your ISP has
asked you to check something or if you are experienced in DSL
port configuration.
Attribute Value Default
DSP Firmware Version DSP code version number N/A
DSP Version DSL driver version number N/A
Connected Current connected state:
True – modem is connected to a remote modem
False – modem is not connected to a remote modem
False
Operational Mode Current operating (connected) mode (modulation) Inactive
State Current state of the device:
Idle – not connected or attempting to connect
HandShake – connecting/hunting for remote modem
Training – connecting/found a remote modem
Showtime – connected to remote modem
N/A
Watchdog
Watchdog timer which confirms that the DSP is
executing a program correctly
N/A
Operation Progress Detailed startup information to be used for debugging N/A
Last Failed
This value is reset to 0 each time a startup is attempted.
If there is a failure, it indicates the reason for the failure.
N/A
Tx Bit Rate Transmit rate (bits per second) of the device N/A
Rx Bit Rate Receive rate (bits per second) of the device N/A
Tx Cell Rate Transmit rate (cells per second) of the device N/A
Rx Cell Rate Receive rate (cells per second) of the device N/A
Phy TXCell Count Transmit ATM cell counter N/A
Phy RXCell Count Receive ATM cell counter N/A
Phy Cell Drop Count UTOPIA cell drop counter N/A
Overall Failure Indicates the cause of failure N/A
Local ITUCountry Code Country code used by the device (modulation specific) N/A
Local SEF
Number of severely errored frame defects received by
the device
N/A
Local End LOS Number of loss of signal defects received by the device N/A
Local SNRMargin The local Signal to Noise Ration margin N/A
Local Line Attn The local attenuation values N/A
Local Tx Power Current transmit power attenuation of the device N/A