User's Manual

錯誤 ! 尚未定義樣式。 User’s Guide 錯誤 ! 尚未定義樣式。
22
The following terms are used throughout this guide in
association with these buttons:
•
Click – point the mouse arrow over the button, menu entry
or link on the screen and click the left mouse button. This
performs an action, such as displaying a new page.
•
Select – usually used when describing which radio button to
select from a list, or which entry to select from a drop-down
list. Point the mouse arrow over the entry and left-click to
select it. This does not perform an action – you will also be
required to click on a button, menu entry or link in order to
proceed.
He lp info rma tio n
In addition to these buttons, you will also see the information
icon throughout the Web pages. The information icon is
followed by a link (called a hyperlink) to another web page. Click
on the hyperlink to display further information about a specific
configuration setting. For example, at the Current Status page,
clicking on the following hyperlink:
displays further information about the details displayed on the
Current Status page.
If you want to display an index of the Help information available
for all web pages, see Help on page 40.
Te sting yo ur Se tup
Once you have connected your hardware and configured your
PCs, any computer on your LAN should be able to use the
device’s DSL connection to access the Internet.
To test the connection, turn on the device, wait for 30 seconds
and then verify that the LEDs are illuminated as follows:
Table 1. LED Indicators
LED Behavior
Power
Solid green to indicate that the device is turned on. If this
light is not on, check the power cable attachment.
Internet
Flashing on/off while data is being transferred. Solid
orange when a valid IP address has been assigned to the
device by the ISP.
USB
Solid green to indicate that the USB connection is
operational.
W-LAN
LINK/Act
Solid green to indicate that the Wireless LAN connection is
operational.
LINK/Act LAN
Flashing on/off while the device is booting. After about 10-
15 seconds, solid green to indicate that the device can
communicate with your LAN.
LINK/Act DSL
Flashing on/off while data is being transmitted. Solid green
to indicate that the device has successfully established a
connection with your ISP.