User's Manual

錯誤 ! 尚未定義樣式。 User’s Guide 錯誤 ! 尚未定義樣式。
56
Ena bling / disa b ling wire le ss ne two rking
Note
Once you have completed the First Time Settings wizard,
wireless networking is enabled on the device by default.
At the Wireless Network page, click on Enable or disable the
wireless network here… The following page is displayed:
Figure 48: Wireless Network: Enable/Disable page
Choose whether to enable or disable wireless networking:
•
To enable the network, click on the Enable radio button and
then click Next>. This takes you through a subset of the
First Time Setting wizard, starting with the page that allows
you to configure the current Wireless Network Name.
Follow the instructions starting from Set the Wireless
Network Name on page 46.
•
To disable the network, click on the Disable radio button
and then click Next>. The next page confirms the disabled
state of the wireless network. If you are happy with this
configuration, click on Confirm Changes. The Wireless
Network page is displayed.
Displa ying de ta ils o f Wire le ss PCs
At the Wireless Network page, click on View details of
connected wireless PCs… The following page is displayed:
Figure 49: Wireless Network: Connected Wireless PCs page
< bad grammar on this page: “The following 1 wireless PCs
are..@>
This page displays the MAC address of the PC currently
connected to your device, together with the signal strength. The
signal strength is the measure of radio frequency (RF) energy