User's Manual

錯誤 ! 尚未定義樣式。 User’s Guide Configuring your Computers
95
Pa rt 2. Config uring IP prope rtie s o n the USB PC
Now that the USB driver installation is complete, you must
configure the USB PC so that its IP properties place it in the
same subnet as the
錯誤! 尚未定義樣式。’s USB port. There are
two ways to do this:
•
The
錯誤
!
尚未定義樣式。
is configured to assign an
appropriate IP address to the USB PC. If you want to use
this automatic assignment feature, called “DHCP server,”
you must configure the USB PC to accept dynamically
assigned IP information. Follow the instruction on pages 82
through 87 that correspond to the operating system installed
on your PC.
•
If you want to assign a static IP address to the PC, follow the
instructions on page 88 and use the following information:
• In the Network and Dial-up Connections window, be sure
to select the icon that corresponds to your new USB
connection (not the one that corresponds to your
Ethernet NIC). When you display properties for the icon,
the following text should display in the Connect Using
text box:
Conexant USB IAD LAN Modem #n
• The USB port on the
錯誤! 尚未定義樣式。 is
preconfigured with these properties:
USB port IP address: 192.168.1.1
USB port subnet mask: 255.255.255.0
Therefore, your PC must be configured as follows:
IP address: 192.168.1.n where n
is a
number from 2 to 254
that does not conflict
with the DHCP
address range.
Subnet mask: 255.255.255.0