User's Manual

6 Modem/Router with Wireless-N User Manual
2
Installing the Hardware
This chapter explains installing Model 4530 hardware. Before installing the hardware
you will need a SIM card to use the Modem/Router’s cellular modem. If you want to
use the Modem/Router for both voice and data you will need a SIM card that supports
voice and data. If you just want to use the Modem/Router for data, then you will
need a SIM card that at least supports data.
To Install Model 4530 follow these steps:
1 Place the Modem/Router near a computer to be used for setup. This computer needs
an Ethernet (LAN) port.
2 Turn off the computer.
3 Attach the antenna to the Modem/Router if the antenna isn’t already attached.
(Remove the antenna from the package. Place the end of the detachable antenna on
the open antenna connection port and rotate the antenna clockwise by hand until it
no longer turns easily. It may take many turns before the antenna is completely
connected). Move the antenna into an upright orientation. The antenna should snap
into place.
4 Insert the SIM card into the slot on the back of the modem as shown below. You
should hear the SIM card click into place.
5 Connect one end of the supplied Ethernet cable to any of the computer’s Ethernet
ports and the other end to any of the Modem/Router‘s LAN ports.
6 Plug the supplied power cube into the Modem/Router, Router and then into a power
outlet. The Modem/Router has completed powering up when the Status light
starts blinking.
Important: Use only the power cube shipped with the Modem/Router. Other power
cubes may damage the device
.