User's Manual

User Rule#
Select a rule from the dropdown menu to indicate when the policy applies. (0)
Always is the default value.
The SNMP Page
You can use the Simple Network Management Protocol (SNMP) page to set up the
capability to remotely manage a computer network by polling and setting terminal
values and monitoring network events. Most users do not need to set up SNMP.
Enable SNMP
Click the Local, Remote, or both checkboxes to enable the SNMP function.
Check Local if you want the Modem/Router to respond to requests from the
LAN. Check Remote if you want the Modem/Router to respond to requests
from the WAN.
Get Community
Set Get Community to the GetRequest to which your device will respond.
Set Community
Set Set Community to the SetRequest that your device will accept.
IP 1, IP 2, IP 3, IP 4
Enter the IP address of your SNMP Management PCs. You must specify
where the Modem/Router should send SNMP Trap messages.
SNMP Version
Select the SNMP Version that your SNMP Management software supports.
WAN Access IP Address
Enter the IP address for WAN access. The default value of 0.0.0.0 indicates
that every IP address can get some information about this device, using the
SNMP protocol.