User's Manual

Chapter 3: Connecting Devices Wirelessly to the Travel Router 35
Method One
Use this method if your client device has a WPS button. This button can be either a
physical button on the unit or a software button in its application.
1 Press the WPS button on your Wireless-N Router and hold it in for seven (7) seconds until
the Wireless LED starts blinking rapidly.
Important! The Registrar (the device configuring the WLAN) goes into the WPS
mode and the Enrollee (the device joining the WLAN) then looks for it. You should
always start the Registrar first. By default your Wireless-N Router is configured as
a Registrar.
2 Click or press the WPS button on the client device.
3 Refer to your client device's documentation for further instructions, if necessary.
Method Two
Use this method if your client device already has a WPS PIN number. The client is the
Enrollee.
4 If you haven't already done so, open a Web browser and type http://192.168.2.1 in the
address bar.
a When the Configuration Manager launches, log in as admin, then select
Advanced > Basic Settings > Wireless to open the Wireless Setup page.
b Click the WPS Setup button to open the Wi-Fi Protected Setup page.
c Select PIN Code from the Config type dropdown menu.
d Enter the PIN number from your client device.
e Click Trigger to start the connection process on the router.
Important! You must do this within two minutes after starting the router.
f On the Wireless-N Router, when the program displays a message that the
process succeeded, click Save to save the configuration
Method Three
Use this method if your client device requests the router’s PIN number. The client is
the Registrar. Use this method if the client(s) are to connect to multiple access points
so that a client will control the configuration instead of the router.
1 If you haven't already done so, open a Web browser and type http://192.168.2.1 in the
address bar.
a When the Configuration Manager launches, log in as admin, then select
Advanced > Basic Settings > Wireless to open the Wireless Setup page.
b Click the WPS Setup button.
c Select Enrollee from the Config Mode dropdown menu.
d Click Generate Pin to generate a new Pin number.
e Enter the router's Pin Number into your client device. Refer to your client’s
documentation for further details.
Important! You must do this within two minutes after starting the router.