Specifications

RTM (Real-time Modulation) is a function in which operating the [FUNCTION] switch or an optional
foot pedal FP01 or FP02 during performance will change the effect parameter settings and the
volume level in real-time.
14
Using the RTM function
Assign the Ct (Control) function to the
[FUNCTION] switch.
Refer to page 8 for information on how to assign
the function.
While playing the instrument in Play mode,
press the [FUNCTION] switch.
According to the settings of the currently-
selected patch, certain effect parameter values
and the volume level are manipulated.
The following elements can be controlled via the
[FUNCTION] switch.
1.Real-time control of the COMP/WAH module
As you operate the FP01 or FP02, certain
parameter values of the COMP/WAH module
change. This control is effective only when an
effect type with a “ ” indication shown on the
left of the display has been selected for the
COMP/WAH module (the effect type that can be
RTM-controlled). (See page 15.) The type of
parameters varies depending on the selected
effect type.
2.Sound-on-sound (See the diagram below.)
The “Sound-on-sound function” adds sound while
looping the delay sound. This function is turned on
and off via the [FUNCTION] switch or the FP01.
This is effective only when “7” (DELAY) is selected
as the effect type of the MOD module and the FB
parameter is set to “ ”. (See page 18.)
When you press and hold down the [FUNCTION]
switch, the Sound-on-sound function is turned on
and the performance data is added to the delay
sound of looping playback. Use the Time (delay
time) parameter to set the interval of the looping
playback.
3.Pedal Pitch Shifter
With the “Pedal Pitch Shifter” effect, the pitch of
the effect sound changes as you operate the
[FUNCTION] switch. This is effective only when
“6” (PEDAL-PITCH) is selected as the effect type
for the MOD module. (See page 18.)
4.Volume
When all the effects described above are disabled,
the volume level changes as you operate the
[FUNCTION] switch.
• You can use effect 1. and 2., or 1. and 3. simultaneously.
• If the Bypass function is turned on, effect 4. is
automatically enabled.
If the FP01 or FP02 is connected to the CONTROL IN jack
of the 2100, operating the [FUNCTION] switch will not
generate any effect, even if the switch function is assigned
Ct (Control).
HINTHINT
Volume
Time
Minimum
value
Maximum
value
[FUNCTION]
switch
Time
Pitch of the effect sound
Minimum
value
Maximum
value
[FUNCTION]
switch
Time
Parameter value controlled by RTM
Maximum
value
value set in
the patch
[FUNCTION]
switch
NOTE
[FUNCTION]
switch
Effect
sound
[Sound-on-sound]
Dry sound
Delay time