Operation Manual

● 18
ADVANCED GUITAR EFFECTS PROCESSOR
The FUNCTION switch can be used to quickly activate muting or bypass, or to adjust the volume or
effect parameters in real time.
There are seven modes for the FUNCTION switch which can be selected by the user. To assign a
function, perform the following steps.
The module LED of the REVERB module starts to flash.
FUNCTION Mode is a global parameter which serves to control the
FUNCTION switch. The setting is not affected by the on/off status of
the REVERB module.
Seven modes are available for the FUNCTION switch, as described
below.
1: MANUAL
Toggle between Manual mode and Play mode. For information on
Manual mode, please refer to page 20.
2: BANK DOWN
Switch the bank to the next lower number (opposite direction from
BANK
FUNCTION
VALUE
ADVANCED GUITAR EFFECTS PROCESSOR
1.COMP
2.BOOSTER
3.OVERDRIVE
4.TALKING BOX
Sens/Gain
(Talking Gain)
Attack/Tone
(Talking Mode)
Level
(MIC Level)
VOLUME RTM
PRE DRIVE RTM
Gain/Top
Tone/Body
Level
ZNR
POSITION
MAIN DRIVE RTM
High/Depth
Midf/Rate/Sens
MidG/Reso
Low/Stage/Inv
Level
EQ RTM
Pitch/Key
Tone/Scale/Time
Shift/Mode/Dly
Bal/Mix
Amp Sim Mode
EFFECT1 RTM
Pitch/Key/Depth
Fine/Scale/Rate
Shift/Mode
Bal/Mix/Peak
SERI/PARA
EFFECT2 RTM
Time(x100mS)
Time(x1mS)
Feedback
Mix
SEAMLESS
DELAY RTM
Time
Tone/FB
Mix
Patch Level
FUNCTION Mode
REVERB RTM
1.OD
3.DIST
5.GRU
7.
METAL
1.3-BAND EQ
2.PHASE
3.PEDAL-WAH
4.AUTO-WAH
1.PITCH
3.DETUNE
4.PEDAL-PITCH
5.STRING
2.HPS 1.HALL1
3.ROOM 1
4.ROOM 2
5.PP-DELAY
2.HALL21.PITCH
3.CHO
5.TREM/PAN
6.RING MOD
1.NORMAL
2.ANALOG
3.HOLD
2.HPS
4.FLG
2.B-OD
4.FUZZ
6.LEAD
8.ACO
PRE DRIVE MAIN DRIVE EQ EFFECT 1 EFFECT 2 DELAY REVERB
TALKING BOX
POSITION SERI/PARA SEAMLESS
FUNCTION MODE BANK
(
VALUE
)
EDIT
(
CANCEL
)
GROUP STORE
1.MANUAL
2.BANK DOWN
3.DELAY(
TAP&HOLD)
4.BYPASS
5.MUTE
6.RTM
7.VOLUME
PRESETUSER
(BOTH) SEAMLESS
U
P
U O
1, 5
4
2
3
FUNCTION Mode
REVERB RTM
EDIT
(
CANCEL
)
Patch Level
FUNCTION Mode
REVERB RTM
VALUE
Assigning a Function to the FUNCTION Switch
STEP
1
Press the EDIT key to activate the Edit mode.
STEP
2
Use the Module Select keys to select the REVERB module.
STEP
3
Use the Parameter Select keys to select parameter 6 (FUNCTION Mode).
STEP
4
Use the VALUE knob to select one of the modes 1 - 7 listed below.
Using the FUNCTION switch
Using the FUNCTION switch