Operation Manual

33 ●
This section describes how to use the RP01 for controlling the RTM parameter set for the patch.
Before connecting the RP01, make sure that the 3000 is turned off.
Connecting the pedal while the 3000 is on can lead to malfunction.
For details, please refer to the section "Using the FUNCTION switch"
on page 18.
If the FUNCTION switch is set to mode 6 or 7, the function of the
RP01 will be different. Please refer to page 34.
For information on making settings for the RTM function, please refer to
page 23.
Whenever a new patch is called up, the RP01 will be in RTM mode.
● As opposed to using the FUNCTION switch on the 3000, the
Control pedal allows continuous variation of the RTM control
target parameter in both directions, and the value can also be
fixed to a desired point.
NOTE
NOTE
NOTE
MODE SELECT
DELAY MODE (PEDAL SW TRIGGER)
RTM MODE
RP01 RP01
RTM parameter is positive
RTM parameter is negative
Reference value
Value of
effect parameter
set by RTM
Reference value
Value of
effect parameter
set by RTM
Using the RP01 for Controlling the RTM Target Parameter (RTM Mode)
STEP
1
Verify that the RP01 is properly connected to the 3000.
STEP
2
Set the FUNCTION switch to one of modes 1 - 5.
STEP
3
Call up a patch for which RTM has been set.
STEP
4
Operate the Control pedal of the RP01 while playing your instrument.
ADVANCED GUITAR EFFECTS PROCESSOR
Using the Remote Pedal
RTM LED of RP01 lights up