Operation Manual

35 ●

This section describes how to use the RP01 for operating the DELAY mode.

Before connecting the RP01, make sure that the 3000 is turned off.

Connecting the pedal while the 3000 is on can lead to malfunction.

• When the selected patch uses the NORMAL or ANALOG effect type,

tap input of delay time is possible.

• When the selected patch uses the HOLD effect type, hold delay

operation is possible.

DELAY MODE LED lights up when the DELAY module of the 3000 is on

and flashes when it is off.

• Operation is the same as when using the FUNCTION switch on the

3000. The STATUS LED serves as function LED. For details, please

refer to "Setting Delay Time With Foot Switch" on page 21 or "Using

Hold Delay" on page 22.

• When the RP01 is connected and DELAY mode is selected, delay

time tap input or hold delay operation cannot be carried out

with the FUNCTION switch on the 3000, also if the FUNCTION

switch mode is set to "3: DELAY (TAP&HOLD)".

* When the RP01 is in DELAY mode, the Control pedal can be

used to adjust the balance between delay sound and original

sound. The integrated switch can be used to turn delay on and

off.

NOTE

MODE

SELECT

MODE DELECT

DELAY MODE

(PEDAL SW TRIGGER)

RTM MODE

DELAY MODE LED lights when

DELAY module of 3000 is on.

Push the Mode Selector

STEP

Verify that the RP01 is properly connected to the 3000.

STEP

Select a patch for which the DELAY effect module is on.

STEP

Push the Mode Selector of the RP01 to select DELAY mode.

STEP

To return to the RTM mode, press the Mode Selector once more.

STEP

Use the foot switch on the RP01 to perform tap input of the delay time, or perform

hold delay operation.

ADVANCED GUITAR EFFECTS PROCESSOR

Using the Remote Pedal

Using the RP01 for Delay Tap Input or Hold Delay Operation (DELAY Mode)