Operation Manual

■ Parameter 1 TYPE (Effect Type)
The following eight effect types can be selected for
the MAIN DRIVE effect module.
Type 1 OD (Overdrive)
Type 2 B-OD (Blues Overdrive)
Type 3 DIST (Distortion)
Type 4 FUZZ
Type 5 GRU (Grunge)
Type 6 LEAD
Type 7 METAL
Type 8 ACO (Acoustic)
Depending on the selected effect type, the content of
parameters 2, 3, 4 and 7 changes.
37 ●
Parameter 1
TYPE
1. OD 2. B-OD 3. DIST 4. FUZZ 5. GRU 6. LEAD 7. METAL 8. ACO
Parameter 2
Gain (←RTM)
Top
1∼30 1∼10
Parameter 3
Tone Body
0∼10 1∼10
Parameter 4
Level
1∼30
Level (←RTM)
1∼30
Parameter 5
ZNR (P)
oF, 1∼7
Parameter 6
POSITION (P)
ME, EM, Pr
Parameter 7
MAIN DRIVE RTM
oF, dn, UP
MAIN DRIVE RTM
−10∼＋10
MAIN DRIVE
ADVANCED GUITAR EFFECTS PROCESSOR
Effect Types and Parameters
■ Type 4 TALKING BOX
When this effect type is selected and you speak into
a microphone connected to the MIC IN jack, the
signal from the microphone influences the sound of
the guitar you are playing. Even if no microphone is
connected, this effect yields an interesting sound.
When this effect type is selected, the MAIN DRIVE
effect module cannot be used.
●Parameter 2 Talking Gain (←RTM)
Determines the amount of distortion.
●Parameter 3 Talking Mode
Selects an effect variation.
The M1 and M2 variation can be controlled with the
optional headset microphone HM01 or another
dynamic microphone.
M1 : Mild sound (with microphone input)
M2 : Wide-range effect (with microphone input)
G1 : Mild sound (with guitar input)
G2 : Wide-range effect (with guitar input)
●Parameter 5 MIC Level
M1, M2: Determines the MIC IN jack input level.
G1, G2 : Determines the guitar jack input
sensitivity.
■ Common parameters for type 1 - 4
●Parameter 4 Level
Determines the module output level.
●Parameter 6 VOLUME RTM (P)
This patch parameter determines whether the patch
volume is controlled in RTM. When set to on, the
FUNCTION switch or optional remote pedal RP01
can be used to control the input level to the
EFFECT1 or EFFECT2 module. For details, please
refer to page 23 and 33.
●Parameter 7 PRE DRIVE RTM
Determines the change direction and control range
for the parameter marked with "¨RTM". When set to
a positive value, the value of the control target
parameter increases when the FUNCTION switch or
remote pedal RP01 is operated. When set to a
negative value, the value decreases. The current
setting of the control target parameter is used as a
reference point, and the range extends from -10 (-
100%) to +10 (+100%). For distortion effect types,
this becomes the setting value of "oF", "UP, and
"dn". For details, please refer to the note on page 25.
This module contains mainly distortion type effects. It also comprises the ZNR settings (patch
parameter) and the connection type settings for the MAIN DRIVE and EQ modules (patch parameter).