Operation Manual

45 ●
ADVANCED GUITAR EFFECTS PROCESSOR
Effect Types and Parameters
REVERB
This effect module contains reverberation effects. It also comprises the Patch Level parameter for
adjusting the overall patch level, and the FUNCTION Mode parameter for selecting the FUNCTION
switch operation.
Parameter 1
TYPE
1. HALL 1 2. HALL 2 3. ROOM 1 4. ROOM 2 5. PP-DELAY
Parameter 2
Time Time (x10mS)
1∼30 1∼99, 1.0
Parameter 3
Tone FB
0∼10 0∼10
Parameter 4
Mix (←RTM)
0∼99, 1.0
Parameter 5
Patch Level(P)
1∼50
Parameter 6
FUNCTION Mode (G)
1∼7
Parameter 7
REVERB RTM
−10∼＋10
■ Parameter 1 TYPE (Effect Type)
The following five effect types can be selected for
the REVERB effect module:
Type 1 HALL1 (Hall Reverb 1)
Type 2 HALL2 (Hall Reverb 2)
Type 3 ROOM1 (Room Reverb 1)
Type 4 ROOM2 (Room Reverb 2)
Type 5 PP-DELAY (Ping-Pong Delay)
Depending on the selected effect type, the content of
parameters 2 - 3 changes.
■ Type 1 HALL1 (Hall Reverb 1)
Bright reverb effect simulating the sound of a
concert hall.
●Parameter 2 Time
Determines the duration of the reverb.
●Parameter 3 Tone
Adjusts the high-frequency range of the effect.
Lower values result in a softer sound with less treble.
■ Type 2 HALL2 (Hall Reverb 2)
Warm reverb effect simulating the sound of a concert
hall. The parameter content is the same as for type 1
(HALL1).
■ Type 3 ROOM1 (Room Reverb 1)
Bright reverb effect simulating the sound of a room.
The parameter content is the same as for type 1
(HALL1).
■ Type 4 ROOM2 (Room Reverb 2)
Warm reverb effect simulating the sound of a room.
The parameter content is the same as for type 1
(HALL1).
■ Type 5 PP-DELAY (Ping-Pong Delay)
Ping-pong effect which bounces the effect sound
between left and right.
●Parameter 2 Time (x10 ms)
Determines the delay time in 10-ms units.
●Parameter 3 FB
Determines the delay feedback amount.
■ Common parameters for type 1 - 5
●Parameter 4 Mix (←RTM)
Determines the mixing balance between effect sound
and original sound.
●Parameter 5 Patch Level (P)
This patch parameter sets the overall level of the
patch.
●Parameter 6 FUNCTION Mode (G)
This global parameter determines the operation of
the FUNCTION switch. For information about the
various modes, please refer to page 18.
●Parameter 7 REVERB RTM
Determines the change direction and control range
for the parameter marked with "←RTM".