Specifications

■ 36
MALFUNCTION? FIRST, CHECK THESE ITEMS
MALFUNCTION? FIRST, CHECK THESE ITEMS.
Problem
Check Remedy
No Sound, or
Extremely Small
Sound
• Is the AC adapter connected correctly
and the power ON?
Turn the power ON by following the
instructions, "GETTING CONNECTED".
• Is the INPUT jack correctly connected to the
guitar, and the OUTPUT jack to the amplifier?
Connect them correctly by following the
instructions , "GETTING CONNECTED".
• Is your shield cable ok?
Try changing your shield cable.
• Is the connected amplifier's power ON?
Turn the amplifier's power ON.
• Is the volume appropriate for the guitar
and amplifier?
Adjust the volume to the appropriate level.
• Are the 3030 levels (Master Volume level,
Patch level, and EQ2 level) appropriate?
Enter the Edit mode (see page13 ) and
appropriately adjust the levels for each
parameter.
• Is the cut with the EQ effect gain
parameter setting too strong?
Enter the Edit mode (see page13 ) and
appropriately adjust the levels for each
parameter.
• Is the volume low for the EXP/VOL
pedal?
Try the EXP/VOL pedal to check.
• Has the volume lowered because the
FP01 is connected to the VOLUME jack?
Try out the FP01 to check.
• Is the 3030 muted?
Release mute by stepping on the foot switch
corresponding to the flashing LED.
Patches Do Not
Switch
• Is the 3030 in Edit (Manual) mode?
If the EDIT LED is lit, it is in Edit (Manual)
mode. Press the EDIT key to return to Play
mode.
• Is the 3030 in Store standby status or
All Initialize standby status?
Press the STORE key to execute the
operation, or press the EDIT key to leave the
standby status and return to Play mode.
EXP/VOL Pedal
Does Not Work
• Is the Pedal Assign parameter "0"? Enter Edit mode (see page13 ), and adjust the
parameter value appropriately.
• Is the effect module that you want to
control, and that was set with the Pedal
Assign parameter, in the ON state?
Enter Edit mode (see page13 ), and adjust the
parameter value appropriately.
• Was the FP01 connected to the VOLUME
jack while the Pedal Assign parameter
was set to "1" (VOLUME)?
In this case, the FP01 volume control has
priority.
• How appropriate are the directions of the
effects set with Pedal Mode and the
values of the parameters to be controlled?
For example, when the EXP/VOL pedal is assigned
to the flanger of the EFF1 effect module, the effect
will not work if the flanger rate is "1" when Pedal
Mode is set to "1".
For this Pedal Mode,control is supposed to cover
the range from the minimum value through to the
value set by the parameter, but the value of the
parameter itself is the minimum value, so the
pedal control cannot make any change and the
EXP/VOL pedal will not work. Adjust the
parameter value to a suitable level.