AP+4 Wireless Router/Access Point User Guide

4 On the Choosing an Operating Mode page, select the way
you want to use the AP+4:
Router/Access Point. In this mode, which is the one most
users will select, the AP+4 links all wireless enabled
computers and other devices to a network and gives those
devices shared access to your broadband Internet
connection.
If you are using the AP+4 as a Repeater, on the Wireless
Basic Setup page at the Mode option, select AP+WDS.
Then, on the WDS Settings page, enter the MAC addresses
of access points you are communicating with.
Ethernet Client. This mode lets up to four computers, game
consoles or other devices plug into the AP+4 for wireless
access to a wireless network. (In this mode, the AP+4 acts
as a full bridge, just passing data back and forth between the
Internet and network devices.)
Wireless ISP. In this mode, the AP+4 connects to the
Ethernet ports of up to four wired PCs or game consoles,
and connects those devices wirelessly to a wireless access
point. Use this mode if you know you need to use the AP+4's
NAT functionality. Most users who need to connect a
computer or game console to an access point should set up
the AP+4 as an Ethernet Client instead.
If you select Wireless ISP mode, use the Wireless Basic
Setup page to configure the AP+4 as a wireless client.
Click Next to continue.
Chapter 1. Installing the AP+4 9