Specifications

Select the effect
parameter
Change the parameter value
Changing the module
on/off condition
Holding down one of these keys will
continuously change the value. Additionally
pressing the opposite key will cause a faster
change. Pressing both keys simultaneously
skips to the first value of the next effect type
in the same effect module.
This is possible only if the basic parameter of
that module (marked with an asterisk in the
illustration ) has been selected.
Use the [+]/[-] keys.
Use the [PLAY/EDIT] selector to
select the effect you want to
change.
The value of the currently
selected parameter is
shown on the display.
(When the 505 II is in edit
mode, a dot (.) is shown in
the bottom right section of
the display.)
Press both [ ]/[ ] foot switches
together.
Terminate the edit mode
To terminate the edit mode and return to the
play mode, set the [PLAY/EDIT] selector to the
"PLAY" position.
4 0
Parameter
value
Lit
Modules and parameters that can be
selected with the [PLAY/EDIT] selector
(1) Patch level
(2) Basic parameters of COMP module (*)
(3) Basic parameters of DIST module (*)
(4) Extended parameters of DIST module
(5) Basic parameters of EQ module (*)
(6) Extended parameters of EQ module
(7) Basic parameters
of ZNR/AMP module (*)
(8) Basic parameters
of MOD module (*)
(9) Basic parameters
of DLY/REV module (*)
(10) Extended parameters
of DLY/REV module
NOTE
When an effect module has been
switched off, the extended parameter
of that module is not shown.
NOTE
Unless you store the edited patch in memory, the
settings you made will be lost when you select a
different patch after returning to the play mode. Do
not forget to store an edited patch that you wish to
keep, as described on page 14.
(1)
(2)
(3)
(5)
(4)
(6)
(7)
(8)
(9)
(10)
12
ZOOM 505 II GUITAR
ZOOM 505 II GUITAR
13
Editing a Patch
Editing a Patch Editing a Patch
The patches of the 505 II can be freely edited by changing the effect
parameter settings. Try editing the currently selected patch to create
your own sound.
Editing a Patch